Thank you for purchasing the Kitchen Scale. Please read all operating instructions carefully before use. Scales are precision measuring devices and should always be handled with proper care. To ensure years of reliable service, keep these simple tips in mind:

•  Do not exceed the scale’s maximum capacity. Overloading your scale can permanently damage it!

• Avoid exposure to extreme heat or cold. Scales perform best at normal room temperature. If temperatures have changed dramatically, calibration and adjustment may be necessary.

•  Allow your scale to warm up for 30-60 seconds before performing calibration and adjustment (if available).

•  Store your scale in a clean, dry location. Dust, dirt, and moisture can accumulate on the weighing sensors and electronics causing inaccuracy or malfunction.

•  Avoid using your scale in close proximity to strong radio wave emitting devices such as computers, cash registers, and cordless phones.

• Always weigh on a flat and level surface, free  from       vibrations and drafts.

• Gently apply all items to be weighed. Do not drop items onto the weighing platform.

•  Avoid dropping your scale. The warranty does not cover damage due to rough treatment or overload.

•  Check the batteries first if you are having any trouble with your scale. This simple step can remedy most scale issues.

• Do not disassemble your scale. This product contains no user serviceable parts.

Battery Installation

1. Before using the scale       for the first time, check       the battery compartment, you need to place a new battery in it or just remove any plastic insulation strips or packaging that may be in place to prevent battery drainage during shipping/storage.

2. If you are replacing the batteries, make sure the positive and negative contacts are properly aligned.

Scale Operation

1. Put the scale on hard and flat, level surface when you use the scale. Soft or descending place in not allow, it will cause inexactness. When you see a “UnST” in the display at the beginning of you turn on the scale, it means that the scale in unstable. You need to place the scale in a stable situation and then turn on again.

2. Press the ON/OFF key to turn the scale on. You will see 5000 at first and then “0g”.

3. Put the fruits or vegetables you need to weigh at the center of glass platform and wait for few seconds, it will keep stable. The LED backlight will light up itself when you turn on the scale. If there is no operation for about 8 seconds, the backlight will turn off itself for save the power. Any other operations will light up the backlight again.

Zeroing The Scale

If you wish to zero out the weight of an item such as a container, follow these steps:

1.       Place the container on the center of the weighing platform.

2. Wait for the weight to stabilize then tap the TARE key briefly.      The  display will reset to zero.

3. Now place the stuff you need to weigh on the scale. Only the stuff in the container will be displayed.

4. When the container and stuff are removed, a negative number will be displayed. Tap TARE to reset the display back to zero again.

Error Codes

1. Lo -Batteries are low. Replace the batteries.

2. O_ld - Maximum capacity exceeded. This scale cannot be used to give measurements over 5kgs when in kitchen scale mode and 350g in pocket scale mode..

3. UnST - Means that the scale in unstable. You need to place the scale in a stable situation for at least 5 seconds and then turn on again.